HB2034 - 492R

Be it enacted by the Legislature of the State of Arizona:

Section 1. Section 41-2065, Arizona Revised Statutes, is amended to read:

START_STATUTE41-2065. Powers and duties; definition

A. The department shall:

1. Maintain custody of the state reference standards of weights and measures that are traceable to the United States prototype standards and that are supplied to the states by the federal government or that are otherwise approved as being satisfactory by the national institute of standards and technology.

2. Keep the state reference standards in a safe and suitable place in the metrology laboratory of the department and ensure that they shall not be removed from the laboratory except for repairs or for calibration as may be prescribed by the national institute of standards and technology.

3. Keep accurate records of all standards and equipment.

4. Adopt any rules necessary to carry out this chapter and adopt reasonable rules for the enforcement of this chapter. These rules have the force and effect of law and shall be adopted pursuant to chapter 6 of this title. In adopting these rules, the director shall consider, as far as is practicable, the requirements established by other states and by authority of the United States, except that rules shall not be made in conflict with this chapter.

5. Publish rules adopted pursuant to this chapter and issue appropriate copies at no cost to all new applicants for licensure and certification. Updated copies of the rules shall be distributed, on request, at no cost to the public.

6. Investigate complaints made to the department concerning violations of this chapter and, on its own initiative, conduct investigations it deems appropriate to develop information relating to prevailing procedures in commercial quantity determination and relating to possible violations of this chapter, and in order to promote the general objective of accuracy in the determination and representation of quantity in commercial transactions.

7. Establish labeling standards, establish standards of weight, measure or count and establish reasonable standards of fill for any packaged commodity, and may establish standards for open dating information.

8. Grant, pursuant to this chapter, exemptions from the licensing provisions of this chapter for weighing and measuring instruments, standards or devices when the ownership or use of the instrument or device is limited to federal, state or local government agencies in the performance of official functions. On request, the department may conduct inspections of the instruments, standards or devices and shall charge a fee pursuant to section 41‑2092, subsection B.

9. Delegate to appropriate personnel any of the responsibilities of the director for the proper administration of this chapter.

10. Inspect and test weights and measures kept, offered or exposed for sale.

11. Inspect and test, to ascertain if they are correct, weights and measures commercially used either:

(a) In determining the weight, measure or count of commodities or things sold, or offered or exposed for sale, on the basis of weight, measure or count.

(b) In computing the basic charge or payment for services rendered on the basis of weight, measure or count.

12. Test, at random, commodities, weights and measures used in public institutions for which monies are appropriated by the legislature. The testing of commodities, weights and measures in public institutions shall include, but not be limited to, items:

(a) That have historically been of short weight, measure or count.

(b) Found to be of short weight, measure or count by other jurisdictions.

13. Test, approve for use and affix a seal of approval for use of all weights, measures and commercial devices manufactured in or brought into this state as it finds to be correct and shall reject and mark as rejected weights, measures and devices it finds to be incorrect. Weights, measures and devices that have been rejected may be seized by the department if not corrected within the time specified or if used or disposed of in a manner not specifically authorized. The department shall condemn and may seize weights, measures and devices that are found to be incorrect and that are not capable of being made correct.

14. Sample and test motor fuel that is stored, sold or exposed or offered for sale or that is stored for use by a fleet owner to determine whether the motor fuel meets the standards for motor fuel set forth in section 41‑2083 and article 6 of this chapter and in any rule adopted by the director pursuant to this chapter. For the purposes of this paragraph, "fleet owner" has the same meaning prescribed in section 41‑2121.

15. Test all mandated stage I and stage II vapor recovery systems that are installed or operated in this state not less than annually and if the systems are determined to be in compliance with the law approve those systems for use and reject, mark as rejected and stop the use of those systems determined not to be in compliance with the law.

16. Inspect facilities at which motor fuel is stored, sold or exposed or offered for sale to determine whether dispensing devices are properly labeled.

17. Publish and distribute to consumers weighing and measuring information.

18. Weigh, measure or inspect commodities kept, offered or exposed for sale, sold or in the process of delivery to determine whether they contain the amounts represented and whether they are kept, offered or exposed for sale in accordance with this chapter or rules adopted pursuant to this chapter. In carrying out the provisions of this section, the director shall employ recognized sampling procedures, such as are designated in appropriate national institute of standards and technology handbooks and supplements to those handbooks, except as modified or rejected by rule.

19. Allow reasonable variations from the stated quantity of contents only after a commodity has entered intrastate commerce. These variations shall include those caused by loss or gain of moisture during the course of good distribution practice or by unavoidable deviations in good manufacturing practice.

20. Prescribe the standards of weight and measure and additional equipment methods of test and inspection to be employed in the enforcement of this chapter. The director may prescribe or provide the official test and inspection forms to be used in the enforcement of this chapter.

21. Apply to any court of competent jurisdiction for a temporary or permanent injunction restraining any person from violating this chapter.

22. Report to the governor on August 1 of each year and at such other times as may be required on the work accomplished under this chapter.

23. Employ such personnel as needed to assist in administering this chapter.

24. Ensure that any information that is required to be filed with the department, that relates to the contents of motor fuels that are sold in this state and that is a trade secret as defined in section 49‑201 is not disclosed.

25. Establish by rule labeling standards for tanks and containers of motor fuels.

B. The director may provide for the periodic examination and inspection of metering devices, including but not limited to devices utilized to measure usage of electricity, natural gas or water by a consumer. Examination and inspection authority shall not apply to metering devices owned by federal, state or local government agencies unless requested by the government agency that owns the metering devices.

C. The director may establish standards for the presentation of cost‑per‑unit information. Nothing in this subsection shall be construed to mandate the use of cost‑per‑unit information in connection with the sale of any standard packed commodity.

D. The director, when necessary to carry out this chapter, may adopt and enforce rules relating to quality standards for motor fuel, kerosene, oil, except used oil fuel, and hazardous waste fuel, lubricating oils, lubricants, antifreeze and other liquid or gaseous fuels. The director shall adopt rules to assure that oxygenated fuels, as described in article 6 of this chapter, that are stored, used, sold or exposed or offered for use or sale are blended and stored, sold, exposed or offered in such a manner as to assure that the oxygenated fuels are properly blended, that they meet the standards set forth in section 41‑2083, and article 6 of this chapter, and in rules adopted pursuant to this chapter, and that dispensers at which the oxygenated fuels are dispensed are labeled as defined by rule of the department in such a manner as to notify persons of the type of oxygenated fuel being dispensed and the maximum percentage of oxygenate by volume contained in the oxygenated fuel. The director of the department of weights and measures shall consult with the director of the department of environmental quality in adopting rules pursuant to this subsection.

E. Testing and inspection conducted pursuant to this chapter shall be done, to the extent practicable, without prior notice, by a random systematic method determined by the director or in response to a complaint by the public. The testing and inspection may be done by private persons and firms pursuant to contracts entered into by the director in accordance with chapter 23 of this title or by a registered service agency or registered service representative licensed pursuant to section 41‑2094. The director shall establish qualifications of persons and firms for selection for purposes of this subsection. The persons or firms conducting the testing and inspection shall immediately report to the department any violations of this chapter and incorrect weights, measures, devices, vapor recovery systems or vapor recovery components for investigation and enforcement by the department. A person or firm that tests or inspects a weight, measure, device, vapor recovery system or vapor recovery component that is rejected shall not correct the defect causing the rejection without the permission of the department.

F. During the course of an investigation or an enforcement action by the department, information regarding the complainant is confidential and is exempt from title 39, chapter 1, unless the complainant authorizes the information to be public.

G. For the purposes of the labeling requirements prescribed in this section, "oxygenated fuel" means a motor fuel blend containing 1.5 per cent or more by weight of oxygen. END_STATUTE

Sec. 2. Section 41-2081, Arizona Revised Statutes, is amended to read:

START_STATUTE41-2081. Sale of commodities

A. A person shall not sell or offer or expose for sale less than the quantity the person represents.

B. As a buyer, a person shall not take any more than the quantity the person represents when the person furnishes the weight or measure by means of which the quantity is determined.

C. A person shall not misrepresent the price of any commodity or service sold or offered, exposed or advertised for sale by weight, measure or count or represent the price in any manner calculated or tending to mislead or in any way deceive a person.

D. Except as otherwise provided by the director, commodities in liquid form shall be sold by liquid measure or by weight, and commodities not in liquid form shall be sold only by weight, by measure or by count, as long as the method of sale provides accurate quantity information.

E. If the quantity is determined by the seller, bulk sales shall be accompanied by a delivery ticket containing the following information unless exempted by rule:

1. The name and address of the vendor and purchaser.

2. The date delivered.

3. The quantity delivered and the quantity upon which the price is based, if this differs from the delivered quantity.

4. The identity in the most descriptive terms commercially practicable, including any quality representation made in connection with the sale.

5. The count of individually wrapped packages, if more than one.

F. Except as otherwise provided in this chapter or by rules adopted pursuant to this chapter, any package kept for the purpose of sale or offered or exposed for sale shall bear on the outside of the package a definite, plain and conspicuous declaration of:

1. The identity of the commodity in the package, unless the commodity can easily be identified through the wrapper or container.

2. The quantity of contents in terms of weight, measure or count.

3. The name and place of business of the manufacturer, packer or distributor, in the case of any package kept, offered or exposed for sale or sold in any place other than on the premises where packed.

4. The price, except as provided in subsections K and L.

G. In addition to the declarations required by subsection F, any package being one of a lot containing random weights of the same commodity and bearing the total selling price of the package shall bear on the outside of the package a plain and conspicuous declaration of the price per single unit of weight.

H. If a packaged commodity is advertised in any manner with the retail price stated, there shall be closely and conspicuously associated with the retail price a declaration of quantity as is required by law or rule to appear on the package. If a dual declaration is required, only the declaration that sets forth the quantity in terms of the smaller unit of weight or measure need appear in the advertisement.

I. The packager of a short weighted item offered for sale is liable under this chapter.

J. If a retail seller engaging in the sale of motor fuel posts the selling price of the fuel on the premises, the seller shall post the selling price only by the price per gallon, except that if the fuel is dispensed by a measure other than whole gallons the seller shall represent the selling price for each unit of such other measure on the individual pump or other dispensing device. If a retail seller engaging in the sale of motor fuel advertises the price of the fuel off the premises, the retail seller shall advertise the price only by the price per gallon.

K. The owner or operator of a motor fuel dispensing site shall ensure a sticker of 3 inches by 5 inches, which depicts the amount of federal and state taxes imposed on one gallon of gasoline shall be displayed on one side of each motor fuel dispenser. The sticker required by this subsection shall be white lettering on a black background or black lettering on a white background to ensure a contrasting color to the motor fuel dispenser and be placed on the upper sixty per cent of the dispenser. The department of weights and measures shall use stickers provided by the department of transportation. A template of the sticker will be placed on the department of weights and measures web site for use by retailers. The department of weights and measures shall, during the course of its normal random inspections, apply the stickers with a compliance schedule of four years from the date of adoption.

K. L. Instead of each package bearing the price as required under subsection F, paragraph 4, the seller may post the price of the package in bold type that measures no less than three‑eighths of an inch on the shelf or display at the point of display of the product. If the price on the shelf or display is less than eighteen inches from floor level, the price shall be angled upward from vertical at least fifteen degrees.

L. m. If the package is offered for sale at a price reduced by a percentage or a fixed amount from a previously offered price, the reduction shall be displayed at the point of display of the package in the manner required by this section.

M. N. On the request of a consumer, a retail seller shall provide:

1. A means of recording prices such as grease pencils, felt markers, scanners or other similar instruments for recording the price.

2. A written statement of the retail seller's policies regarding errors in pricing. END_STATUTE